Concretech Infra Solutions, based in Mandya is a manufacturer of Precast Prestressed Concrete products and associated services to highway, utility, site development and home construction markets all over India.
Contact Info
- Mandya,Karnataka
- +91 91646 07000
- contact@concretechinfra.com
Manufacturers of Precast Prestressed Compound Walls
Wall Tile Adhesive
Wall Tile Adhesive
Tile adhesive is ready-mixed glue used to lay tiles in building structures. It is specially formulated from Portland cement, selected fine aggregates, with some additives to improve its properties for laying tiles.
From decades, we have installed tiles and natural stones using sand, cement and water. As times are evolving, and so does construction techniques, fortunately using adhesives made everything seems easy and fast.
Whether it is a wall tile or floor tile, the tile needs to be stick suitably to the base surface. Tile adhesive is anticipated to hold the tile in place for a long duration without de-bonding problems.
Must for tile on tile application for repair and rehabilitation works Used for fixing ceramic and mosaic tiles on wall surfaces in domestic / commercial / Industrial buildings
High strength formula
Ultimate flexibility
Improved shock and impact resistance
Can withstand thermal stress
Easy to install – fast and economical
Hassle-free and long lasting
Grey color powder
Cement plaster/render, concrete, block wall, fiber cement board, gypsum plaster, gypsum boards (gypsum pores to be sealed with a Tile Primer), tile adhesive for Tile-on-Tile (can be applied on existing tiles and natural stones).
For fixing a variety of tiles (glazed and unglazed ceramic, porcelain, mosaic, vitrified tiles etc.) on horizontal and vertical masonry or tiled surfaces in interiors and exteriors. For fixing a variety of natural stones (marble, granite, marbonite etc.) on horizontal masonry or tiled surfaces in interiors and exteriors. When fixing natural stones and heavy tiles on vertical surfaces the use of Multi-purpose Polymer is mandatory.
Adhesive is suitable for :
- Bedding floor tiles
- Bedding wall tiles
- General tile applications
Product available in 20kg bags
Recommenced Water Addition Ratio
One 20kg bag of Rapid set concentrate requires approximately 20% of pure water to provide workable mix.
50 – 60 sqft/20 Kg. Bag at 3 mm thickness
30 – 40 sqft/20 Kg bag at 6 mm thickness
- Stone Slabs, Vitrified, Ceramic & Porcelain Tiles
- Thickness – 3.5 – 10mm
- Place the required amount of Dry-Mix Wall Plaster into a mixer or onto a non-absorbent surface.
- Add potable water gradually ensuring that it does not wash away any cement and mix thoroughly to ensure an even and consistent mix. Note: Add only enough water to make a workable mix, and do not add excessive water as this will weaken the Dry-Mix Wall Plaster. The recommended amount of water should be added to ensure that the plaster is moist enough to bond to the wall surface, but not so wet that it sags or runs down.
- Form a mortar bed of approximately 3 to 6 mm thick from end to end using a grooved trowel.
- Place the tile on the bed of mortar and remove any mortar that may be squeezed out when the tile is placed and smooth the joint. Any gaps that become apparent must be filled with mortar allowing the mortar to dry before finishing with a ‘pointing’ mix applied in line with the manufacturers recommendations.
- All tools and equipment should be cleaned with water after use.
- Do not re-temper the mortar if it stiffens. Discard the stiffened product and make a new mortar.
60 – 90 minutes at +27°C
Once the tiles are set Into the mortar, they can be adjusted for – 10 minutes (at +27°C).